Magni RTH 4.18, Руководство по эксплуатации и обслуживанию

Страница: 17 / 127

SAFETY AND WARNINGS SECTION 17
Proceed as follows to run manual regeneration.
As indicated by the warning, the vehicle must be
brought to the rest position with the boom retracted
and lowered, stabilised, in idle gear, parking brake on
and ensure that the vehicle is in an open sufficiently
ventilated environment.
Press the button in the top right hand corner to
access the correct alarms page displaying the specific
regeneration activation button.
Once regeneration lasting 30-40 minutes is active, all
vehicle movements are inhibited.
DANGER OF BURNS
During the regeneration, temperatures to the order of
600 °C are reached at the end of the exhaust pipe.
Before activating the regeneration procedures, the
operator
must check the area around the vehicle, if
flammable material is present within a range of
5 metres, and if it is impossible to limit operators
from approaching the area, the vehicle must be
moved to an isolated area to avoid accidental fires or
burns.
Accident prevention in case of
thunderstorms with lightning
Never try to climb on or get down from the vehicle if
lighting strikes in the vicinity.
The operator in the cab must stay inside until the
thunderstorm and lightning is over.
If on the ground during a thunderstorm with lightning,
the operator must move away from the vehicle and
keep at a safe distance.
Spare parts and Equipment
The Certificate of Conformity implies the Manufacturer’s
responsibility only for vehicles without modifications
made by the user or by third parties, and only equipped
with original, approved spare parts and equipment.
Use only original components for vehicle maintenance.
Using components which are not genuine can affect
operation of the vehicle and its life.
Using spare parts that are not genuine can invalidate the
warranty on the vehicle, and induce the Manufacturer to
withdraw the certificate of conformity.
Use of equipment or accessories not approved by the
Manufacturer can cause injury or even death.
Before installing an accessory on the vehicle, check to
make sure it has been approved by the Manufacturer
and the relative load charts are present in the lift
truck software.
In case of doubt regarding the compatibility of an
accessory with the vehicle, contact your dealer.
Make sure all the guards on the vehicle and on the
accessory are fitted in place.
During the maintenance of the accessories, pay special
attention to the sharp and hot parts, and parts which
can crush limbs.