Magni RTH 4.18, Руководство по эксплуатации и обслуживанию

Страница: 60 / 127

60 OPERATION
BEFORE STARTING THE ENGINE
Visual inspection
To ensure the maximum useful operating life of the
vehicle, proceed with a thorough visual inspection
before every start up.
Look around and under the vehicle, checking to make
sure there are no loose or missing bolts, no
accumulated dirt, leakage of oil, fuel and other liquids,
broken or worn parts.
Check the state of the equipment and hydraulic
components.
Check the state and wear of the tyres. If necessary,
adjust the inflation pressure.
Check the levels of the oil, coolant and fluid.
Check the AdBlue® tank level (if present).
Remove all accumulated dirt and debris. Carry out all
the repairs necessary before starting up the vehicle.
Climbing on to or climbing down from
the vehicle
Always use steps 1 and handles 2 to climb on to or
down from the vehicle.
Before climbing on to or climbing down from the cab,
clean all steps and handles thoroughly. Damaged steps
or handles must be repaired immediately.
Do not climb on or down from the vehicle with your
back to it.
Always use three gripping points when climbing up or
down: two hands gripping the handles and one foot on
a step, or two feet on the steps and one hand gripping
the handle.
Do not climb on or get off when the vehicle is in
motion.
Do not climb or get down from the vehicle carrying tools
or other objects. Load the tools required before
climbing on the vehicle. Unload the tools from the
vehicle using a rope to lower these to the ground.
Do not use any of the vehicle’s control devices (joystick
or handwheel) as a grip for climbing up or down.
Driver's seat
Adjust the seat before every work phase and every
time the operator changes.
For instructions regarding the adjustment of the driver’s
seat, consult the relevant section of this Manual.
Always check the nuts, bolts and screws used for fixing
the seat and seat belt. Replace damaged and worn
parts.
The driver's seat is provided with a special sensor to
detect presence of the driver: if the driver is not seated
correctly in the seat in the cab, all the commands
activated will be inhibited.
This is displayed by an intermitted visual signal on the
control panel next to the seat.
1
1
1
2
2
2
SEAT SWITCH