Magni RTH 4.18, Руководство по эксплуатации и обслуживанию, Страница: 58 / 127

58 OPERATION
Boom movements limits
The telescopic boom movement can be limited to
avoid collisions with elements inside the work area
which cannot be removed, like the walls of buildings,
columns or hanging beams. The commands necessary
for controlling the telescopic boom movement limits
are present in the limits page.
To use this function correctly, position the vehicle
parallel or perpendicular to obstacles. In case of an
obstacle in front, centre the vehicle with respect to the
obstacle.
Five controls are available for limitation of the boom:
- Button 1 for height limitation;
- Two buttons 2 for front left and front right limitation
with obstacle in front;
- Two buttons 3 for lateral left and lateral right
limitation with obstacle on the side.
To enable or disable the movements limiting function
as a whole, press button
4 . Every time the function is
enabled, the setting for the last use will be retained.
To activate one of the five functions, press the
corresponding button. The function is active if the
button is blue.
To reset one of the five functions at a new value, move
the telescopic boom near the required limit. Keep the
button corresponding to the function to be limited
pressed for 3 seconds. Check to make sure the
numeric value of the limit is updated.
Hydraulic movements speed
The controls for hydraulic movements speeds
adjustment are present in the limits page.
The buttons available for controlling the hydraulic
movements speed are:
- Buttons 1 , for turret clockwise and anti-clockwise
rotation speed;
- Buttons 2 , for boom lifting and lowering speed;
- Buttons 3 , for boom extension and retraction speed;
- Button 4 , for the quick-fit coupling inclination speed;
- Button 5 , for equipment hydraulic movement speed.
Each button has a number alongside it showing the
speed percentage set with respect to the maximum.
To activate the limitation of the speed of a hydraulic
movement, press the corresponding button.
To modify the speed limit value for a hydraulic
movement, press the corresponding button. Turn the
manipulator selector to select the required
percentage. Press the manipulator selector to confirm
the new value.
To activate or deactivate the hydraulic movements
limitation profile, press button
6 .
Four customised limitation profiles can be saved in
memory. To save a profile in memory, press one of the
four buttons
7 , then set the required limitation profile
using the methods described above.
4
1 2
3
7
6
5
4
1 2 3