Section 7 – Programming (continued)
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
41
7-3. Receiver Programming.
The
inteleSmart
receiver comes preprogrammed.
Additional programming is not normally needed.
After loading and opening the
inteleSmart
program the
first screen is the initial setup screen. See Figure 7-1.
Receiver Programming Screen.
7-4. Downloading Parameters from an
inteleSmart
receiver.
To read current programming, tap with a stylus on the
word “Receiver” at the top of the screen. The top of the
screen will change and the words “Record” and “Comm”
will be shown. Tap on the word “Comm” to show the
menu in Figure 7-2. “Comm” Menu. Turn the receiver
OFF using switch S1. (See Figure 8-1. Receiver Board
Layout for location). Aim the IR port on the PDA at the
upper left hand corner of the receiver, turn the receiver
ON using switch S1 and within 10 seconds then tap the
word “Receive Setting”. An acknowledgement message
will be displayed confirming status down loading.
NOTE:
NOTE
THE RECEIVER IS IN THE PROGRAMMING MODE
FOR ABOUT 10 SECONDS AFTER CYCLING THE
POWER SWITCH. DURING THIS TIME LED DS13,
GREEN, WILL BE ON SOLID AND LED DS15, RED,
WILL FLASH. IF THE UNIT IS NOT
PROGRAMMED OR DATA READ DURING THIS
TIME THE POWER MUST BE RECYCLED TO RE-
ENTER THE PROGRAMMING MODE.
This information can now be saved using the menu
under the word “Record”. This menu allows you to
create new files, open existing files, delete files, save
files and rename existing files. See Figure 7-3. Settings
Menu.
7-5. Saving Settings.
If the settings need to be changed, check the appropriate
boxes for the changes, save the file and send it to the
receiver using the same procedure as was used to
download the settings, only on the PDA tap the
command “Send Setting” instead of “Receive Setting”.
Remember to cycle the ON/OFF switch S1 on the
Receiver to put the unit in the programming mode.
7-6. Programming Frequency.
Select a Frequency (Must be inputted and match the
respective transmitter for system to work):
There should be a label either on the receiver or the
transmitter being replaced listing frequency, it should be
a channel number between AK01 to AK20. Find this
number and tap the “Freq” arrow and select that channel
number.
For more details on receiver frequencies, reading or
programming them without a PDA see Section 7-13.
Record
Comm
New
Open
Rename Current
Delete Current
Save Current
Save Current As
Figure 7-3. Settings Menu.
Figure 7-1. Receiver Programming Screen
Frequency AK01
Type
12 output 2 speed
Receiver Programmer
A1
Receiver access code
1
0
B1
1
0
Status
1 8
Figure 7-4. Frequency Selection.
Frequency AK01
Type
12 output 2 speed
Receiver Programmer
A1
Receiver access code
1
0
B1
1
0
Status
1 8
Record
Comm
Send Settings
Receive Settings
Send App Table
Receive App Table
Beam Record
Receiver ID
About
Figure 7-2. Comm Menu.