Section 6 - Wiring (continued)
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
19
TABLE 1. SINGLE-SPEED PROGRAMMING DIAGRAM.
STANDARD CONFIGURATION HOIST, TROLLEY AND BRIDGE
NOTE
For details on transmitter switch pair interlocks see
telePilot
manual programming section, Section 5-3.4.3 Single-
Speed 10K
telePilot
Lockout Modes on Mode options available in the
telePilot
transmitter and how they control
pushbutton interlocks for the Single-Speed
telePilot.
Latching outputs: Two latching outputs are available:
Output 1, which is set by RX Status Word switch S2-3.
Output 3, which is set by RX Status Word switch S2-2.
RECEIVER And SINGLE TRANSMITTER SWITCH SETTINGS
In the Receiver use the PDA Receiver Programmer to:
o
Set “Receiver access code” and “Frequency”.
o
In the “Receiver Programmer” screen, select under “System” “12 output 1 speed”.
o
In the “Set Status Words” screen, set RX and TX Status Word Switches S1 to S4 as shown below:
X’s are normally OFF (0) but may be turned ON (1) to enable additional features detailed in Section 7-11 Status
Word Programming.
1. In the transmitter:
•
Single-Speed
telePilot
use the PDA Transmitter Programmer to:
o
Set “Receiver access code” and “Frequency”. (Must be same as receiver).
o
Select under “Tx Type” to “1 SPD telePilot”.
o
Select under “System” “10K”.
o
Select under “Mode” (see below) the number of the desired button interlocks.
Modes are: (See telePilot manual for more detail).
Mode 1 is top 2 pairs of buttons interlocked both right and left side.
Mode 2 is top 3 pair interlocked right side and top pair interlocked left side.
Mode 3 no interlocks.
Position
Switch
# 1
2 3 4 5 6 7 8
Rx S2
0
X
X
0 0 0 X
X
Tx S4
0
0 0 0
0
0
0 0
Position
Switch
# 1 2 3 4 5 6 7 8
Rx S1
X X X 0 1 X X
X
Tx S3
0
0 0 0
0
0
0 0
