Section 7 – Programming
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
40
7-1. Receiver Programming Overview.
Historically in Telemotive’s 10K systems the user had to
program the transmitter for frequency, access code plus
all number of additional parameters for a special crane
application. Special relay configurations were
programmed in the transmitter for different types of
crane motor, i.e., ACCO, Demag etc. Now with
inteleSmart
receiver these features only have to be
programmed in the receiver once so that a basic
configured transmitter (frequency, access code and
number of motors) can properly operate any crane
configuration. Also with
inteleSmart
the receiver’s
configurations are easily configured using a PDA.
Read the descriptions below to familiarize yourself with
the
inteleSmart
features. The
inteleSmart
receiver unit
for programming uses a PDA (Personal Digital
Assistant). Such products as Palm Pilot
®
or many other
products using Palm OS
®
4.X or lower can be used to
run the programming software. If unsure if your PDA
will work or for a recommended product contact
Telemotive. The software for the PDA is available on a
disk shipped with your unit, or it can be emailed from
your Telemotive representative.
inteleSmart
PDA software is quite user friendly and is
intended to mimic the dip switch settings used in other
Telemotive products without the inconvenience of
having to open the case. The PDA software allows you
to select frequency, access code, time-out-timer settings,
switch arrangement and crane configuration as in other
Telemotive transmitter products.
7-2. Programmer Setup.
Load the
inteleSmart
programming software into your
PDA, refer to your PDA manual or contact Telemotive
for the appropriate procedure. Once loaded, look for the
Telemotive circle and hook logo labeled “Receiver” for
the appropriate application. Select this application to
begin programming.
With the programmer you can load:
System
type
Frequency
Access
Codes
Key
arrangement
Relay configuration
Tandem disable
Invert crane select
Time-out-timer time
Mode selection
Alarm settings
Receiver