Section 7 – Programming (continued)
Telemotive TR12 inteleSmart Receiver Instruction Manual – 03/01/07
44
7-11. Status
Word
Programming.
7-11.1. RX Status Word S1- 1, -2, -3 and -8.
(Group Code).
GROUP CODE DIFFERS FROM MULTIBOX
IN THAT THE ACCESS CODES DO NOT
HAVE TO BE SEQUENTIAL.
Definition: Group Code capability allows up to
8 transmitters to access a single receiver on a
first come first served basis. Only one transmitter
may control the receiver at a given time. Once a
transmitter has gained control, another
transmitter may not access the receiver until the
controlling transmitter relinquishes control by
transmitting an OFF command to the receiver or
the receiver times out due to inactivity.
WARNING
IF YOU NEED TO ADD GROUP CODE OR
ADD ADDITIONAL TRANSMITTERS
PLEASE CONTACT TELEMOTIVE FOR
ASSISTANCE WITH THIS FEATURE.
FAILURE TO FOLLOW THIS WARNING
COULD RESULT IN SERIOUS INJURY OR
DEATH AND DAMAGE TO EQUIPMENT.
7-11.2. Programming Group Code.
PDA switch settings programmed into the
Receiver Board control turn ON Group Code and
control the number of transmitters. Rx Status
Word Switch S1 switch position for 1, 2 and 3
controls the number of transmitters from 1 up to
8. See Table 7-1. Group Code Switch Settings
for proper Group Code settings.
Table 7-1. Group Code Switch Settings.
Rx
Status
Word
Maximum of
S1 Switch Settings
Transmitters S1-1 S1-2 S1-3
1
0 0 0
2
1 0 0
3
0 1 0
4
1 1 0
5
0 0 1
6
1 0 1
7
0 1 1
8
1 1 1
Group Code Programming Step 1.
Go to the “Set Status Word” screen by tapping
the box marked “Status” on the main “Receiver
Programmer” screen. Turn RX Status Word
switch S1 position 8 ON (1). Rx Status Word
Switch S1 position 8 turns Group Code ON.
Group Code Programming Step 2.
Look at the Table 7-1. below and select the
number of transmitters desired. Program this
number into RX Status Word switch S1 positions
1, 2 and 3 per Table 7-1. Tap the “Save” button
on the lower right hand corner of the “Set Status
Word” screen.
Group Code Programming Step 3.
Select a separate and independent access code
for each of the transmitters to be used on this
receiver. Make sure no Access Codes are
duplicates of another system. Contact
Telemotive if you need assistance in picking
Access Codes.
Group Code Programming Step 4.
In the “Receiver Programmer” screen there will
be a set of boxes numbered with the number of
transmitters desired below the words “Receiver
access code”, as shown in Figure 7-10.
Sequentially tap each transmitter box and enter
the respective transmitter Access Codes. Make
sure all boxes all programmed. Make sure all
transmitters and the receiver are programmed for
the same frequency.
Group Code Programming Step 5.
Save the PDA settings and load the settings into
the receiver and test each transmitter separately.
A1
Figure 7-10. Receiver Programmer Screen with
Group Code Enabled for 6 Transmitters.
(Rx Status Word S1 positions 8, 1 and 3 turned ON).
Frequency AK01
Type
12 output 2 speed
Receiver Programmer
Receiver access code
1
0
B1
1
0
Status
1 8
1
2 3 4 5 6
