M7 DS-201, Инструкция по эксплуатации

Страница: 4 / 92

ADDITIONAL SAFETY RULES
FOR IMPACT DRIVER
1. Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact hidden
wiring or its own cord. Contact with a “live”
wire will make exposed metal parts of the
tool “live” and shock the operator.
2. Use clamps or other practical way to
support and secure the workpiece to a
stable platform. Holding the work by hand
or against your body is unstable and may
lead to loss of control.
3. Do not drill, fasten or break into existing
walls or other blind areas where electrical
wiring may exist. If this situation is
unavoidable, disconnect all fuses or circuit
breakers supplying the worksite.
4. Always wear safety goggles or eye
protection when using this tool.
5. Bits, sockets, and tools get hot during
operation. Wear gloves when touching
them.
6. Wear ear protectors when using the tool
for extended periods. Prolonged exposure
to high intensity noise can cause hearing
loss.
7. Use thick, cushioned gloves and limit the
exposure time by taking frequent rest
periods. Vibration caused by hammer-drill
or Imapct wrench action may be harmful to
your hands and arms.
8. Secure the material being fastened. Never
hold it in your hand or across your legs.
Unstable support can cause loss of control
and injury.
9. Avoid accidental starting. Be sure the
forward/reverse switch is in the OFF
position before inserting a battery pack.
Carrying appliances with your finger on
the switch or inserting the battery pack
into an appliance with the switch on invites
accidents.
10. Remove battery pack before changing
accessories. Accidental starting may
occur because battery appliances with
a battery inserted are in the operative
condition.
11. Be prepared for a reaction torque when
“seating” or removing a fastener. The tool
housing may tend to twist in the opposite
direction of bit rotation when “seating” or
removing a fastener, depending on the
torque setting of the tool.
12. Do not run the tool while carrying it at
your side. A spinning bit could become
entangled with clothing and injury may
result.
13. Place the tool onto the fastener only when
the tool is switched OFF. Rotating driver
tools can slide off the fastener.
14. Do not use this tool as a drill. Tools
equipped with shut-off clutches are not
designed for drilling applications. The
output drive can shut off automatically
and without warning.
15. Be careful when driving long screws.
There is a risk of the tool sliding off the
fastener head, depending on type of
socket or bit used. First test the run-down
of a fastener and pay attention during the
screw-driving process to ensure you do
not injury yourself if the tool bit or socket
slides off of the fastener.
16. For best results, your battery tool should
be charged in a location where the
temperature is more that 32° F (0° C)
but less that 104°F (40°C). Do not store
outside or in vehicles.
4