M7 DS-201, Инструкция по эксплуатации

Страница: 16 / 92

FIG. 7
1. Remove the battery from the tool.
2. Align the rib of the bit holder with the hole
in the base of the impact driver.
3. Insert the screw (included) and securely
tighten the screw with a screwdriver (not
included). The bit holder can be positioned
on either side of the tool.
To remove the bit holder:
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw that
attaches the bit holder to the impact driver.
3. Remove the screw and the bit holder.
1. Lock the trigger switch on the impact driver
by placing the direction-ofrotation selector
in the center position.
2. Insert the bit into the chuck. You will hear
a “click” to indicate that the bit is securely
installed in place.
3. Pull on the bit to check if it installed
securely.
1. Lock the trigger switch on the impact driver
by placing the direction-ofrotation selector
in the center position.
2. Pull the sleeve towards the front of the
tool.
3. The bit should pop out from the chuck
automatically, if not, simply pull out the bit.
1. Install the correct bit.
2. Apply just enough pressure to keep the bit
engaged on the screw.
3. Apply minimal pressure to the trigger
switch initially. Increase the speed only
when full control can be maintained.
Variable speed control must be used with
caution for driving nuts and bolts with
socket set attachments. The best technique
is to start slowly, increasing speed as the
nut or bolt runs down. Set the nut or bolt
snugly by slowing the tool to a stop. If this
procedure is not followed, the tool will have
a tendency to torque or twist in your hands
when the nut or bolt seats.
TO INSTALL THE BIT HOLDER
(FIG.7)
INSTALLING BITS (FIG.8)
REMOVING BITS
TIGHTENING AND LOOSENING
SCREWS
TIGHTENING AND LOOSENING
NUTS AND BOLTS
OPERATION
Bit Holder
Screw
Sleeve
FIG. 8
16