M7 DS-201, Инструкция по эксплуатации

Страница: 15 / 92

ELECTRIC BRAKE
LED WORKLIGHT (FIG. 5)
INSTALLING THE BELT CLIP (FIG.
6)
REMOVING THE BELT CLIP
The LED work-light rings, located around
the shaft of the impact driver, will illuminate
when the trigger switch is depressed. This
provides additional light on the surface of the
workpiece for operation in lower-light areas.
The light will automatically turn off within 10
seconds after the trigger is released.
OPERATION
1. Attach the battery pack to the impact
driver.
2. Position the direction-of-rotation selector
to the left of the tool for forward rotation,
and press the trigger switch to turn on the
mode-indicator light.
3. Press the mode selector to change the
speed: press once for low, press twice for
medium, and press a third time for high.
4. To make the Auto-stop function available,
press and hold the mode selector for three
seconds: the autostop indicator will shine.
When a bolt/nut is sufficiently tightened,
the tool will automatically stop the impact
and rotation after approximately one
second.
5. To turn off the auto-stop function, press
and hold the mode selector for three
seconds again. The auto-stop indicator is
will turn off.
The impact driver is equipped with an electric
brake. When the trigger switch is released,
the electric brake engages automatically to
quickly stop the rotation.
1. Remove the battery from the tool.
2. Align the rib of the belt clip with the hole on
the base of the driver.
3. Insert the screw and securely tighten the
screw with a screwdriver.
1. Remove the battery from the tool.
2. Use a screwdriver to loosen the screw that
attaches the belt clip to the driver.
3. Remove the screw and the belt clip.
Belt Clip
FIG. 6
FIG. 5
15