![background image](http://html1.mh-extra.com/html/m-system/47dm/47dm_operating-manual_3112621068.webp)
68
47DM OPERATING MANUAL EM-9510-B Rev.6
NOTE
• The display depends on the specifications and settings. The above displays show default values.
• Hold down Alarm/
↓
or Scale/
↑
button for 1 second or more to return to Measuring Mode from each parameter.
(4) Parameter shifting in Modbus Setting Mode
In Modbus Setting Mode, pressing Alarm/
↓
button shifts one parameter to the next (clockwise in the following figure).
Pressing Scale/
↑
button shifts one to the previous (counterclockwise).
NOTE
• The display depends on the specifications and settings. The above displays show default values.
• Hold down Alarm/
↓
or Scale/
↑
button for 1 second or more to return to Measuring Mode from each parameter.
Manual sub display reset
*
5
P output
*
5
Continued from the previous page
Continued from the previous page
Latching alarm
*
5
Alarm power ON delay
*
5
Standby sequence
*
5
Scaling error
*
5
*
1 Enabled with the I/O option code ‘6’ or ‘A’ (event tripper input).
*
2 Disabled with “normal” selected for the event trigger mode parameter.
*
3 Disabled with “normal” or “sampling hold” selected for the event trigger mode parameter.
*
4 With the cutout set to OFF, the low-end cutout value setting is locked.
*
5 Enabled with “completely unlock Advanced Setting Mode” selected for the advanced setting lockout parameter.
*
6 Enabled with the I/O option code ‘5’ , ‘9’ or ‘A’ (BCD output).
Measuring Mode
Device address
Baud rate
at once for ≥ 3 sec.
Hold down Alarm/
↓
+ Shift
Modbus Setting Mode
Parity bit
Stop bit
T1.5 timer
T3.5 timer
Long register