LTT SLC-M+ Series, Руководство пользователя, Страница: 82 / 113

Chapter 3 Operation
81
Press
[Auto calibration]
button.
The SLC-M+ will automatically send a
Shift.prn
file to the machine and then marks
a circle on the A4 paper.
AutoCCD will automatically move the CCD and get the image, then calculate the shift
parameters constant.
Finally you will see the number of
[CCD Shift]
will be updated by AutoCCD.
You can do it again. Please don’t move the marked paper, and turn the laser power
key off. Then press
[Auto calibration]
button again. It will do the above processes
all over again.
3.6.2 Operation Flow with CCD
This section explains the basic and common steps to operate SLC-M+ with CCD. If
you want to obtain more detail about operation, please see section 3.7 and 3.8 .
Before executing the steps in this section, please make sure that you have already
finished all steps in chapter 2.
1. Get machine ready.
Turn on the power.
Wait for system start and homing process finishing.
2. Get PC ready
Check the connection between PC and machine
Turn on the PC
Execute AutoCCD.exe
3. Adjust focal height (if necessary)
Put the material on the table.
Move the carriage above the material.
Press and select
[Yes]
.
4. Adjust the right focus of the CCD(if necessary)
Move the CCD to see any pattern
Adjust the working distance until image in CCD monitor is clear.
5. Setting drawing parameter in AutoCCD
Go to AutoCCD / CCD Setting tab
Select the [Calibration] mode.
Go to AutoCCD / CCD Task Control tab
Load drawing file
Setup Mark distance
Setup two point setting