UNITOUR Power System
User Manual
Page 27
1. Tap the required channels to select them
2. Tap a
“Control Source” for the selected channels. If you select Art-Net or sACN you
must also select the required Universe settings
3. Tap
PATCH
and enter the DMX address
These steps are described in detail below.
3.7.1
Control Source
To change the “Control Source” of a channel, tap that channel to select it. Multiple channels
can be selected. A range of channels can be selected by tapping the
first channel
in the
range then
THRU
then the
last channel
in the range. To de-select all channels tap
CLEAR
.
Channels can also be selected by pressing their
CHANNEL SELECT
button located above
each channel’s circuit breaker. Multiple channels can be selected. To select a range of
channels, press and
HOLD the first button
in the range then press the
last button
in the
range.
When a channel has been selected, the channel on the touch screen lights magenta and the
LED above the CHANNEL SELECT button on the output module lights magenta.
When the required channels are selected, tap a
”Control Source” button (at the bottom of the
screen) to set that control source for the selected channels.
When no channels are selected you can tap any of the “Control Source” buttons at the bottom
to identify all of the channels that are set to the source that you tap. The selected source button
and all of the channels set to that source (if any) will turn magenta
Each channel can be individually configured to be controlled by any of the following control
sources,
•
Local (touch screen)
•
DMX
•
Art-Net
•
sACN
Selecting Art-
Net or sACN opens their respective “Setup” menus where you select the
universe that you require. Art-Net or sACN are automatically activated when selected. The
Art-
Net and sACN setup menus can also be accessed from the “Main Menu”. See sections
3.17 and 3.18 for more details.
The way that these signals control the channel depend upon the selected mode of each
channel as described below,
Control
Source
Buttons
Channel 1
is selected
PATCH