UNITOUR Power System
User Manual
Page 21
3.3
Quick Setup
UNITOUR allows every channel in the rack to have its own selectable input source, own DMX
address, and own operating mode. However, in most cases, the configuration is much simpler
so UNITOUR
provides a “Quick” setup that will guide you through the process to select a
control source for all channels, patch the entire rack (if necessary) and allow you to set the
operating modes each channel.
From the “Home Menu” tap
LOG IN
then tap
QUICK
.
When starting a new configuration it is recommended that you clear any previous configuration
and reset the UNITOUR back to the factory default settings. This will set all channels to
“Auto
Power
” mode and “LOCAL” control. If you tap NO and do not do a reset, the output channels
will remain in their last used configuration.
Reset is selected by default so tap
NEXT
.
UNITOUR can be fitted with two types of output modules,
•
UDMT = Dimmer/Switch module
•
USMT = Switch module
The UHM (Unity Head Module) interrogates the rack and looks for the modules that are fitted.
If the rack is connected to 3-phase power they will be automatically recognised as either
UDMT (Dim/Switch) or USMT (Switch) modules.
If the UHM is connected to PoE (Power over Ethernet) (no 3-phase power connected) or if
there are
“Quick-Swap” output modules missing, the UHM will not see the output modules.
You must then tell the UHM what type of modules are or will be fitted.
