PyroTec™ PRO Hardw are User’s Manual, V1.2
65
RT-MN024-1.2 02/21
Status lamp
The status lamp can indicate the following states:
Instrument status lamp signals
Status lamp color:
Instrument status:
Lamp off
The instrument is in idle mode or switched off
Green continuous light
A process is running
Green flashing
The process has been paused; or user prompt; or door locks
open
Red flashing, alarm sound is on
Process is in error state; software displays error message
Red continuously lit
Fatal error, system stops operation
8.2 Operating Modes
Possible
Operating
Modes
Before performing any work on or with PyroTec™ PRO, first read this User’s Manual care-
fully.
The PyroTec™ PRO can be run in three different operating modes:
•
Routine operation mode (operator)
o
This is the normal operating mode, in which the application is run.
o
In this mode, the runtime controller of the corresponding application software
controls the PyroTec™ PRO.
•
Process definition and service mode (application specialist, maintenance personnel)
o
Special tasks are performed in this operating mode, such as adjustments to es-
tablish the process.
Tests to ensure the operating readiness.
o
For these tasks, different software tools are used.
Refer to the “WinKQCL™ Software Manual”.
For service mode, refer to the “Instrument Software Manual”.
•
Setup and service mode (a Lonza approved FAS (field application specialist) )
o
Serves to set up the instrument, to make adjustments and to run tests.
