LMI Technologies FocalSpec, Руководство пользователя

Страница: 37 / 94

37
•
Move the table to the right.
If you enable the Show selection if footer slider, an arrow icon appears in the bottom bar, with which you can
move the table to the selected position and back to the measurement start position.
•
Z-Height (U_XYZ model only) — In this area, you can set parameter Z by enabling the Preview Camera Signal
toggle button. When enabled, you can see live preview of the Z-range. The Z-Height parameters screen is
depicted in the figure below:
Note:
Adjusting Z with the arrow buttons requires pressing the Shift key. Releasing the Shift key stops the Z-
axis move.
You can:
•
Fine-tune the height with the buttons in the Z-Height area. The buttons are:
•
—
10 mm up.
•
—
1 mm up.
•
—
0.1 mm up.
•
—
10 mm down.
•
—
1 mm down.
•
—
0.1 mm down.
•
Select Auto Z to automatically move the scanner down to the focus height.
Note:
Before you select Auto Z , make sure that the sensor is above the focus height.
The Auto Z function detects possible objects in the sensor focus area only.
Tip:
The Z scale of the camera preview window is adaptive. You can adjust the scale with the mouse wheel, as
follows:
•
Down, if adjusted below the green line.
•
Up, if adjusted above the green line.
To zoom in, left click the mouse and drag down to the left. To return to full view, double left-click.
•
Rotation (only visible if rotation unit is installed)
— Enter the desired rotation table angle in the
Angle field.
The Camera Preview Signal mode is depicted in the figure below.
Figure 37 Z-Height