Page 18
Installation & Use – English Guide
LINDY ELECTRONICS LTD
3.6 Keyboard hotkey control
LINDY CPU Switch can be conveniently controlled by selecting channel, autoscan mode or
security locking from the keyboard. All of the hotkey control commands are invoked by holding
down the two hotkeys and then pressing a command key. By default, the two hotkeys are
t
and
s
, although other combinations can be selected by reconfiguring the hotkeys (see section 4.7).
Once the hotkey command has been activated you will need to release the hotkeys and the
command key before a new hotkey command is accepted by the LINDY CPU Switch. H
v
is an exception and this allows you to 'tab through' the ports by holding down the hotkeys and
repeatedly pressing
v
.
The hotkey command are summarised below
(note that the numbers on the numeric keypad do not form part of a valid hotkey) :
Hotkey Sequence
CPU 16 OSD
CPU 8 OSD
CPU 4 OSD
CPU 4
CPU 2
‘HOTKEYs’ &
Select channel 1
Select channel 1
Select channel 1
Select channel 1
Select channel 1
‘HOTKEYs’ &
Select channel 2
Select channel 2
Select channel 2
Select channel 2
Select channel 2
‘HOTKEYs’ &
Select channel 3
Select channel 3
Select channel 3
Select channel 3
-
‘HOTKEYs’ &
Select channel 4
Select channel 4
Select channel 4
Select channel 4
-
‘HOTKEYs’ &
Select channel 5
Select channel 5
-
-
-
‘HOTKEYs’ &
Select channel 6
Select channel 6
-
-
-
‘HOTKEYs’ &
Select channel 7
Select channel 7
-
-
-
‘HOTKEYs’ &
Select channel 8
select channel 8
-
-
-
‘HOTKEYs’ &
Select
channel
9
- - - -
‘HOTKEYs’ &
Select
channel
10
- - - -
‘HOTKEYs’ &
Select
channel
11
- - - -
‘HOTKEYs’ &
Select
channel
12
- - - -
‘HOTKEYs’ &
Select
channel
13
- - - -
‘HOTKEYs’ &
Select
channel
14
- - - -
‘HOTKEYs’ &
Select
channel
15
- - - -
‘HOTKEYs’ &
Select
channel
16
- - - -
‘HOTKEYs’ &
v
Selects the next channel
‘HOTKEYs’ &
Switches off the video signal and display 0. This will cause some monitors to go into standby mode or
switch off. The video signal can be re-enabled by selecting a channel
