Lincoln 82206, Руководство владельца/оператора

Страница: 4 / 27

Page Number - 4
Form 404109
ADJUSTING SPRING TENSION
To prevent premature power spring failure, spring
tension should be ad usted so that it requires at least
two full turns of the reel sheave before the spring is
wound tight.
Should less spring tension be desired, pull hose out from
roller outlet to provide slack and latch reel.
Unwind one loop of hose from reel. Pull excess hose out
through roller outlet and unlatch reel to retract hose.
Check tension and repeat above proce dure until desired
tension is obtained.
ATTACHING CONNECTING HOSES
To prevent damage to connecting hose when install-
ing hose to reel, sufficient clearance must be provided
from outside edge of sheave.
See Figure (2). Remove U-keeper and in let adapter from
swivel body.
If adapter assembly (273065) is damaged, replace at
this time.
Assemble swivel adapter to connecting hose.
Reconnect inlet adapter to swivel body and replace U-
keeper
Connect other end of connecting hose to material supply
line source or connection
FIGURE (3) REEL INSTALLATION AND ADJUSTMENT
REEL INSTALLATION AND ADJUSTMENT
See Figure (3). The guide arm may be positioned in
22-1/2 degree increments as shown. For ease of opera-
tion and increased hose life, the guide arm should be
positioned to minimize hose strain as the delivery hose
is pulled tnrough the roller outlet.
Three studs must be used to securely attach the guide
arm. It may be neces sary to change the position of the
hex head screw and one stud in order to obtain the
desired guide arm position.
The hose clamp must be relocated if the guide arm is
in position B or C. Refer to SERVICE PARTS for hose
clamp location