UMX-OPT-TX150R
User’s Manual
Section 3. Controls and connections
Page 17 / 107
3.2. UMX-OPT-TX150R rear view
Figure 3-2. UMX-OPT-TX150R rear view
SC MM OUT
Connect a 50/125 multimode fiber optical cable (OM4 is
recommended) between the SC MM OUT of the transmitter unit and
the SC MM IN of the receiver unit. (e.g. HDMI-3D-OPT-RX100RA or a
Lightware Hybrid Matrix equipped with fiber optical input cards). For
more information see chapter
4.6
on page
20
.
RS-232 port
9-pole D-sub female connector for standard RS-232 port. Connect a
serial cable between the transmitter unit and the serial device. RS-232
pass-through, third party control and Advanced EDID management are
available via the RS-232 interface. For more information see chapters
4.5
and
5.2
-
0
on pages
20
and
22
-
27
.
USB PORT
Mini USB-B connector for standard USB port. Connect a USB-A
–
Mini USB-B cable between the transmitter unit and the computer.
Advanced EDID management, control and firmware upgrades are
available via the USB interface. For more information see chapter
4.7
on page
20
.
(USB port can be used as USB KVM for HID devices, as well. This
function is under development, available later.)
BAUD RATE ROTARY
The rotary switch selects one of 5 speeds of the serial communication
(#1 .. #4) or the Software Control mode (#0). The #8 and #9 states are
used for special functions. For more information see chapter
5.4.4
on
page
26
and.
EDID MEM. ROTARY
The rotary switch selects one of 10 addresses on every input port.
EDID memories #1 .. #5 contain factory presets and #6 .. #9 are user
programmable. Address #0 enable dynamic EDID emulation which
copies EDID from receiver device’s video output. For more information
see chapter
6.8
-
6.12
on page
41
-
46
.
LEARN BUTTON
Stores the EDID of the display device attached to receiver device’s
video output in the selected memory address between #6 .. #9 on the
selected input port. To learn the EDID, select the desired input and an
appropriate address with the rotary switches and press and hold the
Learn button for two seconds. For more information see chapter
6.10
on page
45
.
Reset button
Hardware reset button. It resets the whole device, however saved
settings and EDIDs will be preserved. This is the same as
disconnecting from power source, and reconnect again.
STATUS LEDS
The LEDs give feedback about state of the unit and the
communications. For more information about names and meanings of
the Status LEDs see chapter
6.1
on page
29
.
DC 5V in
Connect the output of the su5V DC power adaptor.
CAUTION!
Warranty void if damage occurs due to use of a different power
source.
Info:
Use a flat head screwdriver to the rotary swithes that fits into the actuator. Avoid the use of keys,
coins, knives and other sharp objects because they might cause permanent damage to the rotary
switches.
RS-232 PORT
2
USB PORT
3
SC MM OUT
1
BAUD RATE ROTARY
4
EDID MEM. ROTARY
5
DC 5V IN
9
RESET BUTTON
8
LEARN BUTTON
6
STATUS LEDS
7
6
9
2
1
7
3
4
5
8
Содержание UMX-OPT-TX150R
Страница 1: ...UMX OPT TX150R User s Manual ...
Страница 2: ......
