Page | 9
Step 8:
Tools Needed:
Philips screw driver: 2JAY
Note:
Ensure that all wires are properly
connected inside the console. Be careful not
to pinch the wires. Wires only connect one
way.
1) Locate bag labeled
Figure 8.
2) Locate computer console.
3) (
See Figure 8-1
) Connect the white tip 7
pin computer cable wire into the white 7
pin connector on the board. Locate the
green ground wire and connect it to the
grounding terminal to the left of the white
7 pin connector on computer console.
Locate the red 3 pin heart rate cable and
black heart rate ground wire. Connect the
red 3 pin wire to the red 3 pin connector
on the board. Connect the black heart rate
ground wire to the grounding terminal to
the left of the 3 pin connector on the
board.
4) Place the computer console on the
console mast. Make sure the wires fit
inside the computer and computer
console sits flat on the console mast.
5) (
See Figure 8
) Secure four screws to the
back of the console using a Philips screw
driver. Tighten screws.
Figure 8-1
White 7 Pin Connector
Red 3 Pin Connector
Green Ground Wire
Black Heart Rate Ground Wire
