Page | 6
Step 2:
Tools Needed:
Philips Screw driver: 2JAY
1) Locate bag labeled
Figure 2
.
2) Locate black metal cover.
Note:
First fasten screws at the bottom of the
cover, next top and finally the middle.
3) (
See Figure 2
) Secure cover to main
frame by using Qty. six M5x0.8-12
screws. Screw two at the bottom of the
cover, next screw two on top and finally
two in the middle. Using a Philips screw
driver, tighten screws.
4) Tighten all hardware from
Step 1.
Step 3:
Tools Needed:
17 mm socket wrench: 2JAX
Tube of grease: 2K81
Note:
Arms are labeled Right and Left.
Note:
Apply about a finger tips worth of
assembly grease on each pivot point shaft
and bearings prior to connecting arms
.
1) Locate bag labeled
Figure 3
.
2) Locate the left and right handrail
assemblies.
3)
(See Figure 3)
Apply and spread grease
on console tube shafts. Mount the left and
right handrail assemblies to console tube
using one washer first, one spring washer
second and one M10*20 hex bolt last on
each side. Using a 17 mm socket wrench,
tighten hex bolts.
