LGMG MT86H, Руководство по эксплуатации и обслуживанию, Страница: 60 / 165

MT86H Operation and Maintenance Manual
52
Level
Speed
km/h
Air
pressure
kpa
Load
kg
14.00 ‐ 25
Tire of
construction
machinery
36 level
10 1200 11500
15
850
7300
20 7150
25 7000
30 6900
35 6750
40 6700
Remarks
The above data are for
reference only. The specific air
pressure adjustment shall be
subject to Operation
Instructions provided by the
manufacturer.
2) The fitting surface of brake drum and wheel
rim shall be free from paint, grease or other
contaminants.
3) The seal face of wheel nuts shall be kept
clean without contaminants or oil stain.
4) Before installing the wheels, wipe up the
outer circle matching with the wheel locating
hole and final drive housing, and apply a few
grease.
5) Apply a few grease, engine oil or other
anti-seize to the threads of wheel bolts and
nuts.
6) All wheel nuts have right-handed threads.
To install the wheels, pre-tighten the nuts
diagonally with the wheels suspended, lower
down the wheels, and tighten the nuts to the
specified torque*.
* Specified torque of wheel nuts: Use a 36 mm
hexagon socket to tighten MT86 wheel rim bolt
to a torque of 700 - 800 Nm.
7) Each time when a tire is refitted, always
tighten the wheel nuts again after the vehicle
travels 50 km. Thereafter, check and tighten
the wheel nuts again every 1,000 km.
8) Please inflate the tire according to the
“Comparison table of speed, load and air
pressure” (see left table).