55
206-4272
IP Environment Setup
The IP Environment Menu enables you to set up the network features of the STB. If you intend to
create a Master STB Setup for cloning purposes (see Master STB Setup procedure on pages 40 to
42), all IP Environment settings, with the exception of Wired Network Connection settings, the STB
name (editable in the Media Share Menu), and SoftAP settings, may be cloned.
Note:
With the exception of Network Setting configuration, the IP Environment settings are editable
(with the Installer Remote) only if the STB is in Pass-through Mode and read-only when the STB is
not in Pass-through Mode.
Accessing the IP Environment Menu
Note:
When you enter the IP Environment Menu, the Installer Menu is exited (all current settings
are saved automatically upon exit). If you are also in the process of updating Installer Menu items,
you may wish to set all items as needed before you access the IP Environment Menu. Otherwise,
after exiting the IP Environment Menu, you will need to reaccess the Installer Menu to set additional
items.
1. Use the Installer Remote to access the Installer Menu (see “Accessing the Installer Menu” on page
30 for further information).
2. Navigate to Installer Menu item 119 DATA CHANNEL, and press
2
-
5
-
3
+
MENU
to launch the IP
Environment Menu.
Use the Up/Down arrow keys on the Installer Remote to select the desired menu option and then
press
OK
. Refer to the following sections for information on each of the IP Environment setup options.
When you have completed your IP Environment configuration
as required
, press
EXIT
or
on
the Installer Remote to exit the IP Environment Menu.
Pro:Centric Setup
P
ro:Centric options enable you to configure the
STB with the
appropriate settings to connect to the Pro:Centric server. Use the Up/
Down arrow keys on the Installer Remote to navigate between fields.
1. With the IP Environment Menu on display, use the arrow keys
on the Installer Remote to select the
Pro:Centric
menu option.
Then, press
OK
.
2.
Refer to the appropriate subsection(s) below to configure the
STB’s Pro:Centric settings to match those of the Pro:Centric
server.
While the Pro:Centric application (Mode) itself is an additional
feature, the appropriate Pro:Centric server configuration must be
completed to enable E-Z Installation (configuration and software/
firmware) data downloads and, if configured, the Pro:Centric
application download.
Note:
By default, the Pro:Centric Menu initially shows RF
configuration fields. When you select “IP” as the Media Type, the
Data Channel field is replaced with IP Address and Port Number
fields.
(Continued on next page)
Mode
Configuration Only
Media Type
RF
Data Channel
AUTO
Update Event
OFF
Pro:Centric
Network
Pre-loaded Apps
PRO:CENTRIC
^
^
