41
206-4272
Custom Master STB Setup (Cont.)
Custom Master STB Setup Procedure
1. Turn ON the STB/display panel.
The next step depends on whether the EZ-Manager Wizard appears
on the screen when you turn ON the STB/display:
• If the wizard is displayed, the STB is in the required factory default
state. Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the STB to a factory default
condition before continuing with this procedure. See Reference
section, “Restoring Factory Defaults on the STB(s),” as necessary,
for further information.
2. Set Installer Menu items.
This step provides specific instruction only on the Installer Menu items
that should be set on a Master STB. Refer to pages 30 to 39 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 30 for further information).
b) Set Installer Menu item
003 BAND/AFC
, as appropriate.
• Broadcast: Set to 0.
• HRC: Set to 2.
• CATV: Set to 1 (default).
• IRC: Set to 3.
c) Set any other Installer Menu items that affect your TV programming
network
to the required configuration. For example, set the panel
display type (if applicable), enable/disable Aux inputs, set a Start
Channel, etc.
d) After you have adjusted all Installer Menu item settings as required,
and if you do not need to configure any IP Environment settings (see
note below), press
OK
once on the Installer Remote to save your
changes; then, press
OK
again to exit the menu.
Note:
If you intend to configure settings in the IP Environment Menu,
which is accessible from the Installer Menu, you can proceed directly
to step 3. All Installer Menu settings will be saved automatically when
you access the IP Environment Menu.
3.
Configure IP Environment settings.
Note:
You cannot return directly to the Installer Menu from the IP
Environment Menu; thus, you may wish to set all Installer Menu items
as needed before you access the IP Environment Menu. Otherwise,
you will need to reaccess the Installer Menu to set additional items.
Navigate to Installer Menu item 119 DATA CHANNEL, and press
2
-
5
-
3
+
MENU
to launch the IP Environment Menu. Then, complete
network configuration as required.
In particular, if you intend to use
the Wi-Fi Zoning feature, you must configure the wireless network
connection as part of the Master STB Setup. See “IP Environment
Setup” on pages 55 to 62 for further information.
Typical Installer Menu
Adjust the value for this
Installer Menu item, as required.
003 BAND/AFC 001
(Continued on next page)
STB_3000 PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000
ASIC D279
PTC V1.00.023
CPU V3.00.71.01
