LG AMNW07GSJL0, Данные о продукции

Страница: 193 / 443

8. Installation
39
MULTI/SINGLE
Indoor unit
ART COOL Mirror
̰
Connecting the installation pipe and drain hose
1. Align the center of the pipes and sufficiently tighten the flare nut by hand.
2. Tighten the flare nut with a wrench.
3. When needed to extend the drain hose of indoor unit, assembly the drain pipe as shown on the drawing.
̰
Wrap the insulation material around the connecting portion.
1. Overlap the connection pipe insulation material and the indoor unit pipe insulation material. Bind them together
with vinyl tape so that there may be no gap.
2. Set the tubing cutting line upward. Wrap the area which accommodates the rear piping housing section with vinyl
tape.
3. Bundle the piping and drain hose together by wrapping them with vinyl tape sufficient enough to cover where
they fit into the rear piping housing section. Be sure that the drain hose is located at the lowest side of the bundle.
Locating at the upper side can cause overflow from the drain pan through the inside of the unit.
CAUTION
If the drain hose is routed inside the room insulate the hose with an insulation material* so that dripping from
sweating condensation) will not damage furniture or floors.
* Foamed polyethylene or equivalent is recommended.
Indoor unit tubing Flare nut Pipes
Wrench
Indoor unit tubing
Open-end wrench
(fixed)
Connection
pipe
Flare nut
Vinyl tape(narrow)
Adhesive
Drain pipe
Indoor unit drain hose
Insulation material
Vinyl tape(narrow)
Connection pipe
Connecting cable
Vinyl tape (wide)
Wrap with vinyl tape
Indoor unit pipe
Pipe
Gas Pipe Liquid Pipe
Cutting Line
Cutting Line
Good Case Bad Case
* Tubing cutting line have to be upward.