Leviton Z-MAX r24sd, Руководство пользователя

Страница: 57 / 93

Low Voltage Control Wiring,
Z-MAX Remote Relay Panel User Guide, Revision A 8/2005
PK-93194-10-00-0A
Page 51
Low Voltage Control Wiring
Once the power wiring has been completed, control wiring can be
addressed. Control wiring can be divided into two categories:
analog and digital. When dealing with remote relay panels, only
the analog control inputs can be used.
The remote relay panels can accept the following control signals
on any of its inputs:
•
Low Voltage inputs (Switches)
•
Photocells
•
Occupancy Sensors
•
Dry Contacts
•
Analog 0-10VDC Inputs
The specific wiring requirements for each input type is dicsused
on the following pages.
The use of low voltage control inputs on Remote Relay panels is
only available in software release 1.40 and above for both the
master and slave cabinets. If you plan to use this feature,
please make sure that all cabinets have been upgraded.
Additionally, if your cabinet was shipped before 1.40 was
released, the firmware may need to be updated. If you suspect
this is the case, please contact our technical services
department at (800)959-6004.
Each product (and in some cases each model of a product) has
a slightly different layout at the terminals blocks. The specific
functions of each terminal is labeled on the circuit board
adjacent to the terminal blocks. When wiring the inputs, verify
that you are connecting the correct wire to the correct terminal
based on function even if it deviates from that shown in this
documentation. Contact our technical services department with
any undocumented quesitons.
WEB
VERSION