Leviton Z-MAX r24sd, Руководство пользователя

Страница: 37 / 93

Feed and Load Wiring, Line and Load Circuit Wiring
Z-MAX Remote Relay Panel User Guide, Revision A 8/2005
PK-93194-10-00-0A
Page 31
Step 1:
Locate the appropriate location for the relay card
Step 2:
Align the connector from the relay card with the
relay bus board and gently push the two together.
Step 3:
Once firmly seated, use a phillips screwdriver to
drive the mounting screw tightly in place.
If you need to remove the relay cards that
shipped installed from the factory, remove the
shipping screw located near the connector and
discard. This screw is only required for shipping
and not for installation.
Wiring the relays
Step 1:
Connect the line (feed/circuit breaker) side of the
circuit to the "input" terminal(s) on the relay card.
Step 2:
Connect the load side of the circuit to the "output"
terminal(s) on the relay card.
Step 3:
Please note that relay card terminals accept the
following wire sizes:
Mounting Screw
Location
Connector to Relay Bus Board
On bottom of Relay Card
WEB
VERSION