Lenovo ThinkSystem SR150, Руководство по установке

Страница: 63 / 90

Before you install the top cover, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 32 to ensure that you work safely.
2. Make sure all the removed components are installed, and all the disconnected cables inside the server
are reconnected.
To install the top cover, complete the following steps:
Figure 47. Top cover installation
Step 1. Align the posts inside the top cover with the slots on the chassis.
Step 2. Hold the front of the server and slide the top cover toward the front server until it clicks into place.
After you install the top cover, complete the following steps:
1. Install the server into rack if necessary.
2. Reconnect power cords and all external cables.
3. Turn on the server (see
“Power on the server” on page 56 ).
Install a simple-swap disk drive
Use this information to install a simple-swap disk drive.
Before you install a simple-swap disk drive:
1. Read “Safety” on page iii and “Installation Guidelines” on page 32 to ensure that you work safely.
2. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
3. Identify the drive bay in which you plan to install the simple-swap drive.
Notes:
• When SATA drives are installed and connected to SATA connectors 4-7 on system board (without a RAID
adapter installed), the drive number will be reported by RAID utility as drives 4, 5, 6, and 7 (different from
drive bay number)
• When SAS or SATA drives are installed and connected to RAID adapter, the drive number will be 0, 1, 2,
and 3 (same as drive bay number)
Chapter 3
.
Server hardware setup
55