Lenovo ThinkSystem SR150, Руководство по установке

Страница: 23 / 90

Connectors and LEDs on the rear server
Figure 7. Rear view
Table 5. Components on the server rear view
1
PCIe slot 1
5
Ethernet connector 2
2
PCIe slot 2
6
Ethernet connector 1 (shared with XCC network port)
3
Server power connector
7
VGA connector
4
USB 3.1 Gen1 connectors
8
Serial connector
1 2 PCIe slot 1 and 2
Install the PCIe riser assembly:
• PCIe slot 1: PCI Express 3.0 x8
• PCIe slot 2: PCI Express 3.0 x8 (x16 mechanical connector with x8 signal)
For information about the PCIe slots, see “PCIe riser assembly” on page 20 .
3
Server power connector:
Connect the power cord to this connector.
4 USB 3.1 Gen1 connector:
Connect USB devices, such as USB mouse, keyboard, or other devices to these two USB 3.1 Gen1
connectors.
5 6 Ethernet connector 1 and 2:
Each Ethernet connector has two status LEDs to help you identify the Ethernet connectivity and activity.
• Ethernet connector 2: connect server to the internet
• Ethernet connector 1: connect server to the internet, or set server to access Lenovo XClarity Controller
If the LOM adapter is not installed, Ethernet connector 1 can be set as XClarity Controller Network
connector. To set Ethernet connector 1 as XClarity Controller Network connector, start Setup Utility and
select
BMC Settings
➙
Network Settings
➙
Chapter 2.Server components15 Network Settings
Network Interface Port : Shared.
Then, click
Shared NIC on
and select
Onboard Port 1.
7 VGA connector:
Connect a monitor to this connector.
Notes:
• When the front VGA connector is in use, the rear VGA connector will be disabled.
• The maximum video resolution is 1600x1200 at 75 Hz.
Chapter 2
.
Server components
15