Lenovo ThinkSystem SR150, Руководство по установке

Страница: 56 / 90

Step 2. Press the battery straight down until it clicks in place.
After you install the CMOS battery, complete the following steps:
1. Install the top cover onto the server (see “Install the top cover” on page 54 ).
2. Install the server into the rack if necessary.
3. Reconnect power cords and all external cables.
Install the fixed power supply unit
Use this information to install the fixed power supply unit.
To avoid possible danger, read and follow the following safety information.
S001
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
• Connect all power cords to a properly wired and grounded electrical outlet/source.
• Connect any equipment that will be attached to this product to properly wired outlets/sources.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• The device might have more than one power cord, to remove all electrical current from the
device, ensure that all power cords are disconnected from the power source.
S035
CAUTION:
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage,
current, and energy levels are present inside any component that has this label attached. There are no
serviceable parts inside these components. If you suspect a problem with one of these parts, contact
a service technician.
Before you install the fixed power supply unit, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 32 to ensure that you work safely.
Note:
If the server is installed with Delta fixed 300W PSU: when the AC power is dropout without the proper
server power off process, wait for at least 10 seconds to re-plug the AC power to the server.
48
ThinkSystem SR150 Setup Guide