Lenovo ThinkServer TS200v, Руководство по техническому обслуживанию аппаратной части

Страница: 41 / 108

4.
To reinstall the front bezel, align the three plastic tabs on the right side of the
front bezel with the corresponding holes in the chassis, then pivot the front
bezel inward until it snaps into position on the left side.
5. Go to “Completing the parts replacement” on page 61.
Installing or replacing a PCI card
Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, “About this manual,” on page 1 and the
Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace a PCI card.
Your server has two standard PCI card slots, one PCI Express x1 card slot, and one
PCI Express x16 card slot.
To install or replace a PCI card, do the following:
1.
Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 33.
Figure 6. Removing the front bezel
Chapter 6. Replacing FRUs
35