Lenovo ThinkServer TS200v, Руководство по техническому обслуживанию аппаратной части

Страница: 25 / 108

POST Error Message Description/Action
Press TAB to show POST screen Pressing the TAB key permits the user to
toggle between the default POST display
screen and a custom POST display screen.
Error: Non-System disk or disk error
Replace and press any key when ready The BIOS was unable to find a suitable boot
device.
Make sure the boot drive is properly
connected to the computer.
Make sure you have bootable media.
EasyStartup problems
The following table describes the EasyStartup problems and suggested actions to
correct detected problems.
Table 2. ThinkServer EasyStartup DVD
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
resolved.
v See the Chapter 7, “Parts Listing, TS200v Machine Types 0981, 0992, 1008, and 1010,” on page 63 to determine
which components are customer replaceable units (CRUs) and which components are field replaceable units
(FRUs).
Symptom Action
The ThinkServer
EasyStartup DVD will
not start.
v
Make sure the server supports the EasyStartup program and has a startable (bootable)
DVD drive.
v
If the startup (boot) sequence settings have been changed, make sure the DVD drive is
first in the startup sequence.
v
If more than one DVD drive is installed, make sure that only one DVD drive is set as
the primary drive. Start the EasyStartup DVD from the primary DVD drive.
The operating-system
installation program
continuously loops. Make more space available on the hard disk drive.
The EasyStartup
program will not start
the operating-system
medium. Make sure that the operating-system medium is supported by the EasyStartup program.
See the
EasyStartup User Guide for a list of supported operating-system versions. The
EasyStartup User Guide and compatibility notes are available through the EasyStartup
program.
Miscellaneous error messages
Message/Symptom FRU/Action
Changing display colors Display/Monitor
Computer will not power-off. See “Power
Supply Problems” on page 16.
1. Power Switch
2. System Board
3. Riser card, if installed.
Computer will not RPL from server
1.
Ensure that network is in startup
sequence as first device or first device
after diskette.
2. Ensure that network adapter is enabled
for RPL.
3. Network adapter (Advise network
administrator of new MAC address)
Chapter 4. Diagnostics
19