Lenovo ThinkServer TD350 70DG, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 159 / 220

Notes:
• To maintain the EMI integrity and cooling of the server, install a new hot-swap redundant power supply
as soon as you remove the failing one or cover the other bay with a protective shield if you just use
one power supply to provide power.
• Your hot-swap redundant power supply might look slightly different from the illustrations in this topic.
• Use any documentation that comes with the new hot-swap redundant power supply and follow those
instructions in addition to the instructions in this topic.
To install or replace a hot-swap redundant power supply, do the following:
1. Do one of the following:
• If you are installing a hot-swap redundant power supply, locate the bay for the power supply in the
rear of your server. Insert two fingers into the two holes in the protective shield that covers the bay,
and then pull the shield out of the chassis. Store the shield in case that you later remove the power
supply and need the shield to cover the bay.
Figure 107. Removing the protective shield for the power supply bay
• If you are replacing a hot-swap redundant power supply, do the following:
a. Locate the failing power supply in the rear of your server.
Note: On each power supply, there are three status LEDs near the power cord connector. For
information about the status LEDs, see “Power supply status LEDs” on page 33.
Chapter 6
.
Replacing hardware
145