Lenovo 10BN, Руководство по техническому обслуживанию аппаратной части, Страница: 126 / 204

8. Insert the connector and cable of the new thermal sensor into the lower hole 1 in the chassis. Then
align the two tabs on the plastic holder holding the thermal sensor with the two holes 1 and 2 in the
chassis, and push the plastic holder until it snaps into position.
Figure 58. Installing the new thermal sensor
9. Reconnect the thermal sensor cable to the system board. See “Locating parts on the system board”
on page 71.
10. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 81.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 132.
Replacing the cover presence switch
Attention:
Do not open your computer or attempt any repair before reading and understanding “Important safety information”
on page 1.
This section provides instructions on how to replace the cover presence switch (intrusion switch).
To replace the cover presence switch, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 80.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 81.
4. Locate the cover presence switch. See “Locating major FRUs and CRUs” on page 68.
5. Disconnect the cover presence switch cable from the cover presence switch connector on the system
board. See “Locating parts on the system board” on page 71.
120
ThinkCentre M78 Hardware Maintenance Manual