Leica CM1860, Инструкция по эксплуатации, Страница: 51 / 108

51
Leica CM1860/CM1860 UV
Daily Use of the Instrument
7
Warning
The safety gloves included in the (
→
P. 26 – 4.3 Standard delivery - packing list) must be worn when
disposing of the blade!
Lateral movement
If the sectioning results are not satisfactory, the blade holder (on a base here (
→
"Fig. 38") ) can be
shifted sideways in order to use another part of the blade, and to benefit from the entire length of the
blade.
To do so, follow these steps:
1. Turn the clamping lever (
→
Fig. 38- 14 ) to the rear (counterclockwise) to release, and then shift
the blade holder sideways to the desired position.
2. To tighten, turn the clamping lever ( → Fig. 38- 14 ) to the front (clockwise).
Fig. 38
14
Adjusting the anti-roll guide system
You can adjust the height of the anti-roll guide system using the knurled nut (
→
Fig. 39- 8 ):
• If you turn the nut counterclockwise, the anti-roll guide system moves toward the blade.
• If you turn the nut clockwise, the anti-roll guide system moves away from the blade.
If the anti-roll guide system is in the wrong position relative to the blade, the following problems will
result:
»
The section rolls over the glass insert of the anti-roll guide system (
→
Fig. 40- 1 ) .
L
Error: Glass insert not high enough.
Remedy: Turn the knurled nut counterclockwise until the section is pushed between the blade and
anti-roll guide as shown in (
→
Fig. 40- 3 ) .