Operation
30 / 74
1.0
Vento
®
II
4.5.8 Electronic linkage control (EHR) function
The spreader is fitted with EHR signal communication (socket) at the factory. The hydraulic signal is taken from the
7-pole EHR socket on the carrier vehicle or from the sensors attached to the lower link (install magnet with sensor
on lower link - option).
Depending on the carrier vehicle, the signal is output on lifting or on lowering. Check the EHR signal is set correctly
and correct it if necessary.
The start-up/switch-off delay defines after how many milliseconds the spreader is switched on/off after lowering/lift-
ing of the hydraulics. When changing the work position (lower/lift hydraulics) under the set start-up/switch-off delay,
no function is carried out.
The spreader is stopped automatically when the front or rear hydraulics of the carrier vehicle are lifted. The spread-
er can be stopped manually at any time using the control panel.
If the sensor is
active
when the linkage is raised, set the EHR polarity to "High".
If the sensor is
inactive
when the linkage is raised, set the EHR polarity to "Low".
1. Select "EHR signal" menu point.
EHR polarity
High
Low
The EHR polarity selection menu will be displayed.
2. Turn the turn-and-push button to choose between
"High" and "Low".
3. Confirm your selection by pressing the turn-and-
push button.
The entry will be confirmed.
Start-up delay
0.0
s
4. Set the duration of the start-up delay.
Advice
The factory setting for the start-up de-
lay is 0.0 s.
Содержание Vento II
Страница 73: ...Vento II 1 0 73 74 ...