Operating concept
Assigning a channel strip with sources
zirkon User Manual
V 1.2
21/ 58
Assigning a channel strip with sources
According to configuration, the channel strips are pre-
assigned with signals/sources. If you want a different
signal to be assigned to the channel strip please proceed
as follows:
1.
Keep the LCD button in the channel strip pressed
(> 5 sec)!
After about 3-4 secs the LCD display of the central module
changes. The display in the LCD control section shows all
available sources (11 sources max.)
2.
Press the LCD button with the required source!
The source is now assigned to the channel strip.
3.
Releasing the button in the channel strip before
selecting a new source establishes the previous
status!
I cannot assign a new source!
A channel strip is open or the source is already assigned!
Close the fader of the channel strip and carry
out the steps 1 and 2 again! For security
reasons it is not possible to select a new source
while the fader is open.
Assign a source not yet assigned!
?
