mc²96 Installation & Service Guide
Version: 1.0/3
33/65
4. Installation
4.15
SFP Modules
The following SFP modules are available for the relevant MADI and RAVENNA/AES67 ports. All SFPs must be
Lawo-certified (as listed below). SFPs are not included and must be ordered separately. You will need one SFP
for each port.
If fitting SFPs to both MADI and RAVENNA ports, take care not to mix up the SFP types.
Ø
MADI Interface SFP Modules
SFP Module Description
Part Number
MADI, 1310nm, multi-mode fiber, 2km
981/60-80
MADI, 1310nm, single-mode fiber, 20km
981/60-81
MADI, HD-BNC (75 ohm), copper, 100m
981/60-82
Ø
RAVENNA/AES67 Interface SFP Modules
SFP Module Description
Part Number
1000 Base-SX: 850nm, -7dBm, multi-mode fiber, 550m
981/60-10
1000 Base-LX: 1310nm, -3dBm, single-mode fiber, 10km
981/60-20
1000 Base-ZX: 1550nm, 0dBm, single-mode fiber, 80km
981/60-30
1000 Base-T: RJ45, copper, 100m
981/60-60
Installing the SFPs
The SFP modules are hot-pluggable, and so they can be fitted or exchanged while the device is powered.
1
.
Remove the dust caps from both the port and SFP module.
Store these carefully so that they can be replaced if a module is removed.
2
.
Push the SFP module into the rectangular slot.
3
.
Press gently and firmly until the module locks into position.
Attention
: Before removal, please unlock SFP modules to avoid mechanical damage to the slots.
If a module is removed, please refit the port's dust cap to protect the internal components.
You
must
use the correct fiber type for your remote device. Using the wrong fiber type or exceeding the
maximum optical input power can result in malfunction of, or damage to, the optical device.