Lauda PROLINE P 5 C, Руководство по эксплуатации

Страница: 66 / 120

66 / 123 Proline heating thermostat 02/2022

If the tolerance range has been selected too small, it may be that the program does not continue, be-
cause the required tolerance is never achieved.
External temperature control: Especially with ramps, a too close tolerance range can cause undesired
delays in the start phase of the ramp.
No. Pump Out 1 Out 2 Out 3
Start ------- ------- ------- -------
1 4 ------- ------- -------
Pump Menu End Insert Delete

Then continue with to the pump and signal
output setting.

The right-hand part of the entry table appears
as shown on the left.

Here, in the "Pump" field, the pump level and,
in the fields "Out 1" to "Out 3", the contact
outputs of the contact mode (accessory) can
be programmed. With the setting "-------"
the starting value is retained which was either
set before the program start or was defined by
a previous segment in the running program.
Further details are given on the following pages.

A new segment is produced by moving the cell
with the black background to a blank line with
the cursor keys and then pressing the soft key
Insert . The values of the cell located above
it are automatically copied.

If the field in the column T end °C has a black
background, the entry mode "End of segment
temperature" is obtained by pressing the
key. Depending on the setting, that is the tem-
perature, which the thermostat is to achieve on
the internal or external temperature probe.

Enter the value, confirm with the key and
continue to the "Time" entry field with .
Help Menu Screen T
set
T
fix
6 7 8 9 0
1 2 3 4 5
End of segment temperature:
25,
00
Min: -150,00°C Max:450,00°C