Laski F-360 SW, Руководство по эксплуатации

Страница: 21 / 40

21
- If using a ramp for loading or unloading then it must be steady enough with no
slippery surface.
- Such a ramp could be with a max. gradient of 20%. In case of this ramp
gradient it should be preferable if other two persons will assist to you with
such handling.
- After loading fix the machine properly on the loading surface.
- For transport it is necessary to protect the machine against weather effects.
- Any handling/working is allowed on the terrain with its max. permissible
inclination of 11
o
.
- Avoid any handling or work with inclination exceeding the permissible limit
of 11
o
.
- In case of any handling the cutter on a rolling ground we recommend other
two persons to assist you because of its weight.
- Be careful when going down the hill. We recommend pushing the machine
forward, not to tow it.
- When going downhill be careful while using the brake.
- Transport the cutter only if the engine is off and the cutting head stopped.
- It is strictly forbidden to move the machine to site with its cutting head still
turning.
Store the stump cutter always in dry (sheltered) space to protect it against
weather effects.
- Before storage clean all parts of the machine. Use also pressure water for
cleaning of coarse impurities.
- Clean especially oily spots.
- Do not use petrol or similar fluids as a cleaning agent.
- Discharge the used oil into a special bin. Dispose the used filter element
always in accordance with relevant valid laws and local regulations. Protect
the environment.
- Exchange all damaged or worn parts. Use always original spare parts. For
spare parts contact your dealer or authorised services.
- A faulty machine should be marked in a proper way to avoid its putting into
operation by other persons before being repaired.
- Check up its right tire pressure.
- Before putting the machine aside for a longer time change the engine oil.
- Swing on the grip and lean it against the engine to save some space around the
machine.
- Always put the machine aside on a flat and solid floor and block it against
unwilling motion.
- Check up coated surfaces. Repaint the spots and conserve them if needed.