Laski F-360 SW, Руководство по эксплуатации

Страница: 28 / 40

28
- Keep the given intervals for checks of bolted joints.
- After every working shift check up tightening of bolted joints, particularly
rotating parts and completeness of other parts, such as fixation of blades and
subgroups on framing.
- Any servicing is allowed to be done at standstill only.
- Provide your machine shops with suitable extinguishers and first-aid kits to be
accessible anytime at fire risk. Keep ready necessary telephone numbers for
emergency cases (fire brigade, emergency).
- Do not smoke while handling lubricants, oils and fuel. Keep open fire away.
- Store fuel canisters and other flammable materials (cleaning rags) separately.
Keep them away from heat sources. Protect the environment.
- Avoid any toxic gas vapours and dust formation. Dangerous vapours may arise
if coats warm up while welding (gas burner) or grinding. Such works should
be done in well-ventilated rooms or in free space only. Keep applicable
regulations concerning coats and solvents. Remove old paints before welding.
If some parts have to be grit-blasted or re-ground, avoid inhalation of abrasion
dust and use necessary personal protective equipment (breathing mask).
Having used any solvent before welding, rinse treated surfaces with soap
water and wait for about 15 minutes (flash time) and let the spots fully
evaporate.
- For repairs and servicing use reasonable local lighting and a portable safety
lamp (24 V). This lamp should be equipped with a safety grid to avoid contact
with oily spots - self-inflammation hazard. Keep your working place clean and
dry.
- Any damaged or worn parts should be replaced immediately. Remove
accumulated old lubricants, oil and keep all parts clean.
- Discharge used oil into a special bin (no packages after meals or drinks).
Dispose used oil always in accordance with applicable laws and local
regulations. Protect the environment.
- Use always original spare parts and proper tools.
-
For lifting use always means of proper carrying capacity only. It is possible to
use a crane (clamps) with suspension at the given lashing points marked with
chain symbols
.
Engine Oil
Change
The first oil change after 20 working hours and next changes
every 100 hrs. Change the oil always when the engine is turned
off and still warm. Discharge the used oil into a bin through the
drain plug on an adapter behind the cutting head. Having
discharged the whole volume screw up the drain plug and fill