LaserStar iWeld 900 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 127 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
127
Fuse Replacement External / (Figure 2)
General Steps for External Fuse Replacement
1. To check or replace any fuse, shut off key switch and Mains power switch.
2. Disconnect the AC power cord from wall and from the product.
3. Remove foot pedal cable. Wait at least five minutes.
External Fuses/Rear of Machine
(Refer to
Figure 2
&
Table 1
))
1. Verify AC power has been disconnected
2. Move machine to allow access to rear
3. Remove external fuses and check & replace as needed.
4. Re connect AC power & Test
Figure 2
(Mains Power Panel)
(*)Caution-
Check the VAC label & ID label on the rear of the machine and
compare with the power conditions at the installation site.
Table 1
Fuse # LaserStar© Part
No.
Amperage/Voltage
Type
Use
120 & 230 Volt AC Version
1 & 2
405-4320-100 10.0A/250VAC/Time-
Lag/5 X20mm Cartridge
Mains Power
Foot Pedal
Connector
(*)
AC Voltage
Input/Disconnect
(Reference ID
Label for Specific
Voltage, Current
& Hz)
Fuse #1
Fuse #2
Voltage
Label (VAC)