LaserStar iWeld 900 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 34 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
34
If any work has to be carried out on voltage-carrying parts, a second person must
be there who can switch the device “off” at the power switch, if necessary (see
the section entitled NOTES ON MAINTENANCE).
Particularly Dangerous Points

Particularly dangerous points must be labeled as such. The various
Warning Labels and their location on the product are described in the
section entitled “LABELING.”

There is
increased danger
when the welding chamber / area is open and
the interlock switches are simultaneously bridged (model dependent).

Above all, never trigger a laser pulse while your hands or fingers are
directly in or under the crosshair of the stereo microscope.
Emission of Noxious Gases and Vapors

Avoid welding vapor by correct use of the inert gas.

The laser radiation produced by this laser product is capable of melting,
burning or vaporizing almost any material. Depending on the composition
of the work piece, gases and vapors dangerous to health may be
produced. The user should filter air exhausted as required by OSHA
regulations (see “Installation”).

Do not use this product on non-metallic materials, especially plastics.
Structural Modifications to the Laser Product

Do not make any modifications or additions to the laser product.

All structural modifications require the written approval of LaserStar
®
Technologies.

Immediately replace all parts that are not in perfect condition.

Use only
original LaserStar
®
Technologies
replacement and
consumable parts.
IMPORTANT: There is no guarantee that parts purchased from companies other
than
LaserStar
®
Technologies Corporation
will meet the stipulated
requirements as to safety and performance.