LaserStar iWeld 900 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
48
Inert Gas
For the inert gas (example-argon, nitrogen, etc.) connection, the product is
equipped with a quick-acting, compressed-air connector for connecting plastic
tubing. Specifications:
Inert Gas (Pressure Regulator)

Maximum operating pressure 3.8 bar (55 psi / 0.38 MPa)

Minimum operating pressure 0 bar (0 psi / 0 MPa)
Inert Gas (Flow Regulator)

Typical Flow Range 10 to 30 CFH
(Note: The flow rate should be adjusted to achieve the required surface
finish at the lowest flow rate to minimize the cost of the inert gas.)
Distilled Water
The water tank must be filled up with distilled water before the product is turned
on for the first time. The distilled water used should be genuine distilled water.
The filling up procedure is described in section
IX / Service A or B / Initial
Filling & Refilling of the Distilled Cooling Water which is model dependent.
Electromagnetic Compatibility
This device meets the EMC standards listed in the Declaration of Conformity and
the Declaration of Compliance.
Disassembling (Preparation for Transport)
To prepare the product for transport over minor distances, you only have to
unplug the power supply and the inert gas supply and loosen the locking brake(s)
on the front wheels.
The distilled water can be left in the distilled Water
Bottle, but the distilled Water Bottle must be removed from the enclosure /
machine!
It is recommended to empty the Distilled Water Bottle before storing or
transporting over longer distances (transport by truck). For this purpose,
reference the section
IX / Service A or B / Changing the Distilled Water &
Replacing the Distilled Water Filter (model dependent).
Do not store or transport the device at a temperature below 3C
(38°F) if the distilled cooling water remains in the tank or laser
head (danger of frost)