LaserStar iWeld 900 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 66 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
66
>Fire the Laser

Press the foot pedal (Note: The weld
parameters can be optimized by using
the Digital Messaging Touch Screen
Display or the Joystick(s).)
(*)-Do not position your hands in or under the crosshair.
Pressing the pedal switch will release a laser pulse causing
burning
The operator can use the rotary control / dimmer control located in the
welding chamber / area to set the brightness on the work piece. (Note:
The rotary control may be on the outside of the machine [model dependent]).
Check the brightness through the stereomicroscope. The appropriate brightness
depends on the properties of the work piece material.
Use the Digital Messaging Touch Screen Display or the Joystick(s) to set the
required welding parameters.
If the reference value for voltage is reduced, the Safety Shutter is closed for
safety reasons.
For inert gas welding, the gas outlet at the end of the gas tube is to be positioned
near to the laser focal point. A position adequate for most applications is at the
edge of the visual field of the stereomicroscope above the focal plane.
The exact positioning of work pieces must be carried out in all three dimensions:
 Horizontal dimensions:
The exact position is controlled by the crosshair.
 Vertical dimension:
The exact positioning is found if the surface of the
work piece appears sharp (in focus).
Action of the Operator System Response
> Look through the stereomicroscope
and join the work pieces together.
Adjust them as necessary.

The crosshair shows the exact
position of the laser focal point.
> If the welding point appears sharp
within the crosshair, press the pedal
switch half way.

The gas supply will be enabled
> Fully press the pedal switch until it
stops

The view shutter shortly blacks out,
the visual field and the laser pulse will
be released.