Landoll Bendi B40i4, Руководство оператора

Страница: 22 / 66

2-4 F-808-R0
RECEIVING AND INSPECTION
Figure 2-1: Battery Disconnects

DANGER
7. Disconnect the negative cable (black) first, then the
positive (red) and lay the cables to the side.
8. Undo the 2 - 3/8 - 16 hex lock nuts and remove
battery clamp bracket. The batter should be free to
move.
9. When installing the new battery, it must be pushed up
against the tray weldment and centered.
10. Connect the positive battery cable (red) to the
positive terminal on the new battery and the negative
battery cable (black) to the negative terminal on the
new battery.
Storage, Towing or Shipping
Truck Storage
If the forklift is to be stored for a length of time:
• The truck should be stored indoors within a
temperature range of +35° F (2° C) to +115° F (46° C)
and a relative humidity of 90%, preferably less.
• The truck should be raised with the tires at least 2” (51
mm) off the floor and the frame set on large wooden
blocks. Hard polyurethane tires, over long periods of
time can develop flat spots that may not return to
normal when the truck is returned to service,
rendering the tires defective.
• If the truck must be stored outside, it must be covered
securely with a tarp, or other water-resistant material.
Continued exposure to sunlight will cause
deterioration of rubber tires, gaskets and hoses, as
well as vinyl seat coverings, etc.
Towing the Truck
If the truck breaks down and cannot be repaired at that
location, it may be towed by attaching a suitable hook
and chain to the tow pin in the rear of the truck. See
Figure 2-2. Remember with no power to the truck being
towed, steering will be difficult. Carefully and slowly tow
the truck backwards to your service repair area.
An operator must be on the towed truck, wearing a seat
belt.

WARNING
Figure 2-2: Tow Pin
Bendi B40i4 Forklift towing instructions:
1. With ignition off and park brake pedal released locate
the brake release pump/valve assembly and towing
instructions inside the left side engine compartment
access door. See Figure 2-3.
Be certain there are no loose wires or tools that
could bridge the two battery terminals. If
conductive material connects the two terminals
arc flash, severe burns, or death may occur.
• Make sure the towing equipment is capable of
handling the weight of the truck being towed.
• Never lift a truck using straps, chains or
hoists of any type.
• Never connect lifting equipment to the
operator’s compartment overhead guards.
• Never use the truck to tow materials.
• Never tow a truck that is carrying a load.
• Never connect towing equipment to the mast.
• For better traction, partially load the truck
doing the towing.