Landoll Bendi B40i4, Руководство оператора

Страница: 61 / 66

5-7
Unusual Noises
The operator, as well as the maintenance technician,
should be aware and take action on any unusual noises
that may surfaced.
The type of noise, such a grinding or a growl, as well as
the location of the noise can determine if or what type of
maintenance needs to be taken.
Most grinding noises may indicate a need for mast rail
lubrication or a faulty wheel bearing.
Growling noises can indicate faulty hydraulic pumps or
simply low oil in the hydraulic tank.
Any unusual noises should be noted in the daily check
sheet and reported to the person in charge of repairs and
maintenance immediately.
General Truck Lubrication
Inspect lubrication points. See Figures 5-4 and 5-5.
These lubrication points along with proper recommended
lubricants ... See Table 5-1 on page 5-7 ... are designed
to extend the service life of the truck and prevent major
problems, causing costly downtime.
Figure 5-4: Rotation Bearing Grease Points
Recommended Lubricants
See Table 5-1 below for recommended lubricants.For
specific areas to lubricate the forklift - See Figure 5-5.
Table 5-1: Lubrication Chart
Name Lubrication Comments
1. Chain SAE40W oil or Bowman Heavy Load Red Grease Clean and reoil
2. Upright Rail Chassis Lube or Kendall SR-12X Lubricate inner sides of upright rails
3. Rotation Bearings Texaco Ref. C & C #880 Use standard lubrication gun
4. Steering Knob Light weight oil Lightly oil
5. Engine SAE 10W30 API “SL” Drain, flush and refill
6. Hydraulic Reservoir Conoco Power flow HE (ISO Grade 46) Filtered to
ISO 4406 cleanliness code 15/13/11 or equivalent
Grade oil filtered to 15/13/11. Drain, flush and refill
7. Tilt Cylinders Texaco Ref. C & C #880 Use standard lubrication gun
8. Articulating Axle
Bearings Texaco Ref. C & C #880 Use standard lubrication gun
9. Load Wheel Axle Texaco Ref. C & C #880 Use lubrication gun and adapter for
flush type fittings
*Failure to refill with oil that meets ISO 4406 cleanliness code 15/13/11 may void the warranty. Typical
“NEW” oil DOES NOT meet this specification. Contact Landoll Corporation or your lubricant supplier for
recommendation.