LANCIER Monitoring ACS 10000, Руководство по эксплуатации

Страница: 20 / 28

Page 20
Read out ACS Values
Menu selection:
Menu D1
>Disp. Device : ACS
Press softkey „select“
Menu D2.1
>ACS – Current Values
Press softkey „select“
Display D3.1 shows up:
The magnified value above shows the „top
value“ (
C ) (see section „Set up top value“),
here „Operating Hour“.
The two values below can be scrolled by the
softkeys (
A ) „up“ and „down“ and show con-
secutively the following values:
C
- Contact : open or close State of a dry contact
(e.g. door or water level switch etc.)
- Power : on or off Operating voltage is on or off
- Compressor : on or off Compressor runs or is shut-down
- Runtime : value sec Last compressor runtime in seconds
- Operating : value h Total operating hours of the equipment
- Humidity : value %rh Relative humidity of the output air in %
- Air Temp. : value °C Temperature of the output air in °C
- Ext. Temp. : value °C Ambient temperature in °C (option „external
temperature sensor“ must be installed)
- Comp.Temp. : value °C Compressor temperature at cylinder in °C
(option „compressor temperature sensor“
must be installed)
- Pressure : value bar Pressure of the output air in bar (option
„external pressure sensor“ must be installed)
- Flow : value l/h Amount of the output air in liters per hour
(at option ACS-
F only)
Operating Hour
12345 h
>Contact : open
Power : off
______________________
up | down | back