1.3 SELECTINg A LOCATION FOR THE DISpENSER
Connecting lines can be run through the back of the dispenser or extend down through a counter
cutout. Seal the dispenser directly on the countertop. Counter Cutouts for each unit are located in the
Section 7. Illustrations, Parts Listings and Wiring Diagrams.
A. Select a level, well-ventilated, accessible location away from direct sunlight (avoid) or overhead
lighting (convenient to water, soda, and syrup lines and open type drain), a properly grounded
electric supply and ensure sufficient clearance for air circulation.
If an icemaker is not installed, sufficient clearance must be provided, to allow for filling the ice
compartment with a five gallon bucket (a minimum of 16 inches is recommended). Lancer does
not recommend the use of shaved, flake, nugget, or pellet ice in the dispenser. The dispenser will
only operate properly with cube ice
.
B.
The selected location should be able to support the weight of the dispenser, ice and possibly an
icemaker being installed after counter cut out is made.
Total weight (with icemaker) for the IBD22
unit, IBD25 unit, IBD30 unit, or IBD44 unit could exceed 800 pounds (363.6kg).
C. Unit may be installed directly on the countertop or on legs supplied with the unit. If installed
directly on the counter, the unit must be sealed to the countertop with an FDA approved sealant.
If an icemaker is to be mounted on top of dispenser, do not install dispenser on legs.
FIgURE 3. SELECTINg A LOCATION - 22” IBD UNIT DISpLAYED (NO ICEMAKER)
OPERATIONS AND SERVICE MANUAL PN 28-0255/11
11
i
CAUTION/pRECAUCIóN/ATTENTION
i
FAILURE TO MAINTAIN SPECIFIED CLEARANCE WILL CAUSE THE COMPRESSOR TO OVERHEAT
AND WILL RESULT IN COMPRESSOR FAILURE.
i
SI NO DEJA EL ESPACIO LIBRE ESPECIFICADO EL COMPRESOR
PUEDE RECALENTAR Y FALLAR.
i
LE FAIT DE NE PAS MAINTENIR LE DéGAGEMENT SPéCIFIé FERA SURCHAUF-
FER LE COMPRESSEUR ET AURA COMME CONSéqUENCE UNE DéFAILLANCE DU COMPRESSEUR.
NOTE: Fill ice with merchandiser intact.
Содержание 4400 Series
