Lamborghini Caloreclima TITAN 150, Инструкция по использованию, установке и обслуживанию

Страница: 123 / 144

TITAN
123
EN
cod. 3541Z410 - Rev 01 - 09/2022
Table of faults
Table 6- List of faults
Fault
code
Fault Possible cause Cure
01 No burner ignition
No gas
Check the regular gas flow to the boiler and that
the air has been eliminated from the pipes
Ignition/detection electrode fault
Check the wiring of the electrode and that it is
correctly positioned and free of any deposits
Faulty gas valve Check the gas valve and replace it if necessary
Insufficient gas supply pressure Check the gas supply pressure
Trap blocked Check the trap and clean it if necessary
Card fault Check the card
0PR 150
Flame present signal with
burner off
Electrode fault Check the ionization electrode wiring
Card fault Check the card
03
Overtemperature protec-
tion intervention
Heating sensor damaged
Check the correct positioning and operation of
the heating sensor
No water circulation in the system Check the circulating pump
Air in the system Vent the system
05
Fan protection interven-
tion Fault F15 generated for 1 hour (consecu-
tive)
See fault F15
06
No flame after ignition
phase (6 times in 4 minu-
tes)
Ionization electrode fault Check the position of the ionization electrode
and replace it if necessary
Flame unstable Check the burner
Gas valve Offset fault Check the Offset adjustment at minimum power
air/fume ducts obstructed
Remove the obstruction from the flue, fume
extraction ducts, air inlet and terminals
Trap blocked Check the trap and clean it if necessary
07 High fume temperature
Exchanger dirty Clean the exchanger
Exchanger deteriorated Check the integrity of exchanger
Sensor does not indicate the correct tem-
perature
Check the fume sensor or replace it
08
Heating sensor 1 (flow)
overtemperature indica-
tion
(Viewable only in the
History Menu)
insufficient system water circulation check water circulation
09
Return sensor overtempe-
rature indication
(Viewable only in the
History Menu)
insufficient system water circulation check water circulation
10 Flow sensor 1 fault
Sensor damaged
Check the wiring or replace the sensor Wiring shorted
Wiring disconnected
11 Return sensor fault
Sensor damaged
Check the wiring or replace the sensor Wiring shorted
Wiring disconnected
1PR 150 DHW sensor fault
Sensor damaged
Check the wiring or replace the sensor Wiring shorted
Wiring disconnected
13 Card parameter fault Wrong card parameter setting
Check the card parameter and modify it if
necessary.